Заказать запчасти 
Запчасти Case IH 425
- (2) - INTRODUCTION (May 8 2002 3:22:00.0027 PM)
- (3) - INTRODUCTION - CONTINUED
- (A-02[A]) - SAFETY CHAIN
- (A-02[B]) - SMV EMBLEM AND LIGHT BRACKET SOCKET
- (A-02) - PRODUCT GRAPHICS
- (A-03) - HITCH
- (A-04) - HITCH PIVOT ASSEMBLY
- (A-05) - BALE CHAMBER
- (A-06) - BALE TENSION, MANUAL
- (A-07) - MAIN FRAME
- (A-08) - WHEEL AND AXLE RH
- (A-09[A]) - WHEEL RELOCATOR LH ATTACHMENT
- (A-09) - WHEEL AND AXLE LH
- (A-10) - POWER TAKE-OFF DRIVE SHAFT CLUTCH
- (A-11) - PTO SHAFTS WITH CHAINS, REAR, FITTED WITH LIP SEAL JOURNAL UNITS
- (A-12) - PTO DRIVE SHAFT, 26 IN. MINIMUM COMPRESSION FOR USE ON TRACTORS WITH 14 IN. STD DRAWBAR
- (A-13) - PTO SHAFTS WITH CHAINS, FRONT, FITTED WITH LIP SEAL JOURNAL UNITS
- (A-14[A]) - PTO SHAFT SUPPORT
- (A-14) - PTO CENTER BEARING AND BRACKET
- (A-15) - MAIN DRIVE
- (A-16) - PLUNGER STOP, UP TO 1979
- (A-17) - PLUNGER STOP, 1980 AND SINCE
- (A-18) - PLUNGER
- (A-20) - PACKER DRIVE
- (A-22) - PACKER BEARINGS AND SUPPORT
- (A-23) - PACKER FINGER
- (A-24) - CROSS CONVEYOR
- (A-25) - FEED OPENING
- (A-26) - NEEDLES AND NEEDLE GUARD
- (A-27) - SLACK ARM
- (A-28) - KNOTTER DRIVE FRAME AND BREAST PLATE
- (A-29) - KNOTTER AND RELATED PARTS
- (A-30) - KNOTTER DRIVE CHAIN AND REAR SHAFT
- (A-31) - KNOTTER
- (A-32) - TUCKER FINGERS, UP TO 1979
- (A-33) - TUCKER FINGERS, 1980 AND SINCE
- (A-34[A]) - AUGER DRIVE CHAIN
- (A-34) - KNOTTER SHAFT BRAKE
- (A-35) - AUGER AND AUGER DRIVE SUPPORT
- (A-36) - PICKUP GAUGE WHEEL ATTACHMENT
- (A-37) - PICKUP
- (A-39) - PICKUP DRIVE
- (A-40) - PICKUP COVER
- (A-41) - TWINE CHEST
- (A-42) - BALE LENGTH CONTROL
- (A-43) - BALE COUNTER
- (A-44) - BALE CHUTE ATTACHMENT
- (A-45) - BALE CHAMBER EXTENSION
- (A-46) - PLUNGER CRANK SHIELD
- (A-47) - LIFTING JACK
- (A-48) - SPECIAL SHIELDS
- (A-49) - FLYWHEEL SHIELD
- (A-50) - HITCH CLEVIS STRAP
- (A-51) - TRAILER HITCH
- (A-52[A]) - TOOLBOX
- (A-52) - BALE TURNER ATTACHMENT, WHEN ORDERED