Справочник запчастей Case IH PTA270 (02-02) - ENGINE ELECTRICAL, CAT 3306 ENGINE (06) - ELECTRICAL со схемами

1

1-2805

SWITCH

oil pressure

1шт.

If recurring problems with the oil pressure switch, ref. 1, and or the oil pressure sender, ref. 2, a mechanical oil pressure gauge can be installed using kit 35-1665T91 see below for components.

1шт.

2

1-2227T2

SENDER UNIT

SENDER, oil pressure

1шт.

If recurring problems with the oil pressure switch, ref. 1, and or the oil pressure sender, ref. 2, a mechanical oil pressure gauge can be installed using kit 35-1665T91 see below for components.

1шт.

3

FUEL SOLENOID, Cat part

1шт.

4

SENDING UNIT, tachometer, see Figure 01-25

1шт.

5

20-1305T1

TEMPERATURE SENDER

SWITCH ,water temperature, Replaces p/n 22-731

1шт.

Superseded, old P/N is not used any longer, the new P/N is to be used in all cases, old P/N should be removed from existing inventory, it is recommended that the old part not be used under any circumstances

1шт.

6

20-1466T1

SWITCH

water temperature, Replaces p/n 22-861, code E

1шт.

Superseded, old P/N is not used any longer, the new P/N is to be used in all cases, old P/N should be removed from existing inventory, it is recommended that the old part not be used under any circumstances

1шт.

7

1-8036

HARNESS

WIRE HARNESS, engine (ASN), with slave solenoid, ref. 10 as shown below

1шт.

Superseded, old P/N must be used on models prior to S/N break new P/N will fit models after the S/N break only

1шт.

20-1191T1

WIRE HARNESS, engine (ASN), with slave solenoid, ref. 10, mounted on cab, PT models

1шт.

20-1259T1

HARNESS

WIRE HARNESS, engine (ASN), with slave solenoid, ref. 10, mounted on cab, PTA 270 only

1шт.

20-1425T1

HARNESS

WIRE HARNESS, engine (ASN), DIT & DITA engines only, PT models

1шт.

Engine wire harness 20-1422T1 was used on a temporary basis on some early PT models with the DIT engines. it has now been replaced by 20-1425T1 on a code E basis.

1шт.

8

ALTERNATOR, see Figure 02-14

1шт.

9

STARTER, see Figure 02-11

2шт.

10

20-1608T1

SOLENOID

replaces 06-1496, (B), 1 mtd on cab on later models, not used on models with DIT and DITA engines

2шт.

See Figure 2-10 for info regarding the mounting of the slave solenoid on the front of the cab

1шт.

Superseded - Old P/N can be used for all models, but order new P/N when stock is depleted.

1шт.

11

22-555

WIRE, slave solenoid to ground, qty on models with slave solenoid mounted on cab, not used on models with DIT and DITA engines

2шт.

12

22-33

CABLE

WIRE, starter, Serial Range: groung-engine

1шт.

13

22-631

CLIP

CLAMP

5шт.

14

22-1080

ELECTRICAL WIRE

WIRE, fuel, Serial Range: solenoid-ground

1шт.

15

22-814

HARNESS

WIRE, solenoid to glow plugs, not used on DIT and DITA engines

1шт.

16

51-265

MOUNT solenoid, not used on DIT and DITA engines

1шт.

17

19-1

BOLT,Hex, 1/4" - 20 x 3/4", Gr 5

CAPSCREW, 1/4 UNC x 3/4, not used on DIT and DITA engines

2шт.

18

19-223

WASHER,1/4"

1/4, not used on DIT and DITA engines

2шт.

19

19-76

NUT,1/4"-20, G5

1/4 UNC, not used on DIT and DITA engines

2шт.

20

DRIVE TIP, tachometer, see Figure 01-25

1шт.

21

1-6950T1

CABLE

starter to junction block, not on PTA 270

1шт.

22

1-6663

HARNESS

WIRE HARNESS, alternator

1шт.

23

31-395

REDUCER,3/4"-14 Male NPTF x 1/2"-14 Female NPTF

ADAPTER

1шт.

24

1-5693

BRACKET, mounting hardware listed below

1шт.

19-17

BOLT,Hex, 3/8" - 16 x 1", Gr 5, Full Thd

CAPSCREW, 3/8 UNC x 1

2шт.

19-18

BOLT,Hex, 3/8" - 16 x 1 1/4", Gr 5

CAPSCREW, 3/8 UNC x 1-1/4

1шт.

19-78

SPECIAL NUT,3/8"-16, G5

3/8 UNC

1шт.

19-117

LOCK WASHER,3/8"

3/8"

1шт.

25

31-1070

CLAMP,5/8", 3/8" Bolt, Double

2шт.

26

31-607

REDUCER

ADAPTER

2шт.

20-1870T1

KIT

repair, wire harness connector

1шт.

35-1665T91

NO LONGER SERVICED

KIT oil pressure gauge, mechanical, used with ref. 1 or 2 if needed

1шт.

20-2422T1

GAUGE

oil pressure

1шт.